Grab your new Wifi and Bluetooth card.There is an adhesive substance on the back, but a light pull should be enough to remove it. Pull the Bluetooth card straight out towards you. Remove the single gold antenna connector. Use the same screwdriver to remove the single screw holding the card in place. Locate the Bluetooth card on the right side of the computer.With everything disconnected from the left side of the card simply slide the entire Wifi card to left, removing it from its slot and set it aside. Disconnect these by lightly pulling them towards you, it should not take much force. Between the two screws you will see three gold antenna connectors. Using a small screwdriver undo the top and bottom screw on the left side of the Wifi card.Later we will be passing wires behind the column. Also note the metal dividing column in the center. Note the Wifi card highlighted on the left and the small Bluetooth card on the right. With the tray removed your computer should look like Figure 2.This will unlock the tray, allowing you to pull the entire thing out in one piece. There are two switches on the front, simply press them in so that they point out towards you. Near the bottom you will find the processor tray. Begin by disconnecting your Mac Pro's power supply and any other devices currently connected your Mac Pro.
0 Comments
Leave a Reply. |